Diffusers OD, KD, AKD, LD, LDP, etc.

Round and square diffusers are used to supply and remove air. Due to the high ejection capacity, it is possible to distribute air at large values of the operating temperature difference (the difference between the indoor air temperature and the supply air temperature). With a significant bandwidth, they create a small noise level.
Models: OD-1, OD-2, OD-3N, OD-10, KD-1, KD-2, KD-15, KD-16, etc.

---

Vortex diffusers are designed for air conditioning of low rooms with a height of 2.6 to 4 m and a temperature difference between incoming air and indoor air from +10K to -10K. The vortex jet of air causes a high induction of air in the room.
Variable vortex diffusers are used for sudden changes in the air conditioning mode (heating, cooling). Suitable for rooms up to 10 m high. The recommended temperature difference between incoming air and indoor air is from +10K to -10K. By adjusting the plates (manual or motor), the desired ventilation mode is easily adjusted. These diffusers are suitable both for industrial facilities and for rooms with high comfort requirements.
Models: OD-4, OD-5, OD-7, OD-8, OD-9, OD-15, OD-11, OD-11V, OD-14, OD-17, KD-8, etc.

---

Linear diffusers are designed for the supply and removal of air in rooms with a height of 2.5 to 4 m. They are adapted to supply both warm and cold air, especially where there are very strict requirements for comfort. Due to the high degree of induction, they are also used in systems with variable air flow.
Spirochannel diffusers can be installed in any part of the channel system. Adapted for the supply of both warm and cold air.
Models: LD-13, LD-14, LD-15, LD-17, LD-18, LD-19, LD-20, LD-16N, LDP-14, SKD-13D, etc.

---

• Round diffusers. Technical specifications.
• Square diffusers. Technical specifications.
• Vortex diffusers. Technical specifications.
• Variable vortex diffusers. Technical specifications.
• Linear diffusers. Technical specifications.
• Spirochannel diffusers. Technical specifications.

---